SELECT CIP-25 PELLETS are primarily recommended for use to control corrosion and aid in solids removal while helping breeding grounds for micro-organisms in water injection systems (tanks, wells, and flow lines).
SELECT CIP-25 PELLETS can be used to treat certain hard to reach areas in water injection systems. Dead areas such as rat-hole, annulus space above the packer, and the bottom of the water supply tanks may be reached and more easily treated with SELECT CIP-25 PELLETS.
SELECT CIP-25 PELLETS can be used to control corrosion in oil wells, gas wells, and cooling towers.
SELECT CIP-25 PELLETS are very economical (as compared to conventional corrosion control operations). The use of corrosion pellets saves investment in chemical pumps, drums of liquid chemical, hazardous liquid chemical spills and maintenance of equipment.
TREATMENT DETERMINATION & PROCEDURE FOR PRODUCTION OPERATIONS
SELECT CIP-25 PELLETS dissolve slowly and releases the chemical into the system. The amount required is based on the volume of water to be treated and severity of corrosion attack to the metal surfaces. The best results are achieved by using a larger initial slug treatment (30 to 60 PPM daily) based on the weight of total water volumes produced until the corrosion problem is under control or desired amine residual achieved, then reduce to smaller periodic treatments (15 to 30 PPM daily) thereafter. EXAMPLE: An initial slug treatment of 60 PPM would require 2.10 lbs. of Corrosion Inhibitor Pellets per 100 BBL (4,200 gal.) of water to be treated. A small application scoop is provided with each container of product sold.
It is often best to slug the system with product and then add regularly to maintain control of the problem.
SELECT CIP-25 PELLETS are a white to off-white pellet with a specific gravity of 1.13-1.17. This pellet will therefore fall quite readily in Heavy Brine.
20 lbs. poly pail and 250 lbs. fiber drum.
Refer to MSDS sheets prior to using this product.
FOR INDUSTRIAL USE ONLY.
As with all industrial chemicals, contact with eyes or skin should be avoided. Wash thoroughly with water. Pellets should be stored in a cool dry place. Always remove pellets from the container with the scoop provided while wearing rubber gloves to avoid skin contact. Goggles are advised.
DISCLAIMER OF LIABILITY
The information in this bulletin is believed to be accurate, however all recommendations are made without warranty since the conditions of use are beyond Select Industries, Inc. control. Select Industries, Inc. disclaims any liability in connection with the use of the information, and does not warrant against infringement by reason of the use of any of its’ products in combination with any other material or in any process.