Corrosion Inhibitor Stick (Type A)

Description

Corrosion Inhibitor Stick Type A is water dispersible and oil-soluble sticks that contain a blend of Imidazolines which have excellent filming characteristics and low emulsion tendencies. This unique blend gives effective corrosion control for most oil field corrosion problems.

Application

Corrosion Inhibitor Stick Type A can primarily be used to control corrosion problems found in producing oil and gas well systems. Corrosion Inhibitor Stick Type A can be used to treat hard-to-reach areas. Dead areas such as the annulus space above the packer, rat-holes, or the bottom of water supply tanks may be easily treated with Corrosion Inhibitor Stick Type A.

TREATMENT DETERMINATION

The number of Corrosion Inhibitor Stick Type A required is based on the volume of total fluid produced (oil or condensate plus water). Field experience indicated that for most corrosive environments the best results are achieved by using a larger initial slug treatment (80 PPM daily) until the problem is under control then reduce to smaller periodic treatments (40 PPM daily) thereafter. EXAMPLE: An initial slug treatment of 80 PPM would require approximately 0.67 lbs or Corrosion Inhibitor Stick Type A per 24 BBL (1000 gallons) of total fluid produced.

PRODUCT SPECIFICATIONS

FormSolidMelt Point135 f
ColorBrownSolubility in WaterDispersible
pH4.8 – 5.8Solubility in BrineDispersible
Specific Gravity1.094Solubility in CrudeSoluble

Safety and Handling

Please review SDS prior to using this product. As with all industrial chemicals, contact with eyes or skin should be avoided. Wash thoroughly with water if contact with skin is made. Sticks should be stored in a cool dry place. Always remove stick from plastic bag or cardboard tube before using. Bag or tube can be used as a glove to avoid contact with hands.