
Well Rescue Pack
Product Uses
The Well Rescue Pack was specifically designed as a last resort for your watered up gas well. Dead gas wells lack the agitation required to benefit from conventional soap sticks or liquid foamer. Generally, once a well is dead, unless you are able to shut it in for long periods and build up enough bottom hole pressure to unload the fluid, your options are limited to expensive mechanical methods (swab units, gas lifts, pumps, etc.)
Product Description
The Well Rescue Pack is a kit assembled with cost savings in mind. Each kit will include thirteen (13) 100% active foamer sticks as well as thirteen (13) high performance gas producing sticks. When used as directed, the foamer sticks are dispersed into the downhole fluid and the gas producing sticks create the agitation to foam the fluid.
Treatment Recommendations
The Well Rescue Pack was designed with a “one well, one pack” application in mind. In most cases, the typical treatment would be to drop the thirteen (13) 100% active foamer sticks into the well. The foamer sticks will need time to dissolve and disperse into the fluid column. Generally in no agitation, 70 degree fluid, 3 hours will be needed to achieve this. In deeper, hotter wells, less time will be required. After the required time, the thirteen (13) high performance gas producing sticks are dropped into the well. After the sticks have been given time to reach fluid, open the master valve of the well 25%. As fluid starts to unload from the well, slowly continue to open the master valve. Note: Even in cases where the Well Rescue Pack fails to unload the well, benefits will be seen from the foamer downhole when mechanical operations are used to remove fluid from the gas well.
CAUTION
As with all industrial chemicals, contact with eyes or skin should be avoided. Wash thoroughly with water. Sticks should be stored in a cool dry place. Always remove stick from plastic bag or paper tube before using. Bag or tube can be used as a glove to avoid contact with hands.
DISCLAIMER OF LIABILITY
The information in this bulletin is believed to be accurate, however all recommendations are made without warranty since the conditions of use are beyond Select Industries, Inc. control. Select Industries, Inc. disclaims any liability in connection with the use of the information, and does not warrant against infringement by reason of the use of any of its’ products in combination with any other material or in any process.